Bob asked ... Charger fault?    |    Terry nelson asked ... How to remove the flexible shaft from a curved shaft ryobi t?    |    Matt Longmore asked ... Non-start on Flymo XLT 250?    |    John asked ... How to fix my fireplace?    |    Ian Scott asked ... Remove cover off gas boiler?    |    Click here to ask your question

My Poulan Pro 255 starts and idles fine but dies when given the gas?

As above.
Tim, April 2007
try adjusting high speed jet ,the one on the right . turn jet in till just bottoms out not to tight. back out one full turn try starting.go quarter turn out ,starting saw each time,try it each time until it runs smooth .

brian, September 2007
Sounds like you either need to adjust the carb. or change the fuel filter.

Bob Runser, April 2007