to get toilet to flush I have to repeatedly have to push handle.
the cistern has correct level of water.

steve, June 2007

change of diaghram plastis oval sheet or change internal mechanism

anjum zaman, October 2007

Thanks Tom The Taxi for your reply

tony..tsp, July 2007

sorry i meant I was referring to the sarcastic one...not you...God what a mess I am....lol Sorry

Tom the Taxi, July 2007

i was referring to the reply that you got not to you as you were trying to help and Tony was being pedantic. Good luck to you

Tom the Taxi, July 2007

Hello ‘ Tom The Taxi ‘ and ‘Sonray Heating’

I think the reply I gave to Steve’s question would have been a help to him and to others with same problem. I am sorry I seem to of offended your good selves by a few typing errors, spelling mistakes and incorrect punctuation, however I use capitals as it is still easy to read.
I am not a great typist I admit, and if I had to go over everything I would not have time to complete the answer ,which I think is more important(By the way writing in caps is not rude, if it means anything ,it means attention! or that I am shouting)however I apologise if you find it offensive
I notice no comment or criticism was made of the content therefore I presume you approve and indeed one of you mentioned that “I may be good at plumbing”
I would suggest to you, that the content is the main thing and as long as it is eligible, it becomes helpful, that’s all I am trying to be.
Best regards
Tony….Tsp

Tony, July 2007

appalling i think is the word that you were attempting to spell

Tom the Taxi, July 2007

TONY TSP HEATING

you may be good at plumbing, but your english is appauling
no full stop's or paragraphs

and it's rude to write in cap's lock.

sonray heating, July 2007

YOUR SYPHON DISC IN THE CISTERN IS SPLIT THE DISC CAN BE REPLACED HOWEVER NEW SYPHONS COMPLETE ARE NOT THAT EXPENSIVE NOW AND IS RECOMMENDED AS YOU DO NOT HAVE TO WORRY ABOUT GETTING THE RIGHT SIZE OR SHAPE DISC,HOW TO REPLACE DEPENDS ON TYPE OF WC,LOW LEVER OR CLOSE COUPLE A DIY SITE SHOULD GIVE TO STEP BY STEP PICTURE OF HOW TO DO THIS A LITTLE TIP IF YOU HAVE A CLOSE COUPLE WC{CISTERN SITS ON PAN}WHEN YOU PURCHASE NEW SYPHON GET A NEW 'RUBBER DOUGHNUT TO THIS SEALS BETWEEN CISTERN AND PAN AND IS ONLY A FEW QUID NOTHIN WORSE THAN DOING THE JOD AND FINDING SMALL LEAK FRON OLD SEAL AND YOU HAVE TO TAKE ALL CISTERN OFF AGAIN AND USE BRASS SCREWS AS REQUIRED NOT STEEL

TONY TSP HEATING, June 2007