What should the spark plug gap be?
What are the settings on the carb screws?
When I start the saw it runs on high RPMs but dies on low and then is hard to restart. Sometimes I have to play around with the choke. Its getting very difficult to start?
What should I do?

PJ Dolan, February 2005

i am looking for an exhaust ut no 100453 it is about 24 years old. ser no 472770033

jim, February 2010

i have a homelite textron and all i did was clean the diafram and spray starting fluid in spark plug socket and choke it and spray starting fluid in there and clean carb

andrew 10 yrs., November 2008

I Use .025 gap & it performs adequately. Good Luck

Reg., August 2006

no idea what the plug gap should be, probably just straight out the box would do. high rpm on starting: adjust idle screw to let less fuel in. hard to restart after dying on low sounds like slight flooding. you may need to adjust the throttle screw to let less fuel in, and if it has a float carb (one with a bowl) raise the float a bit. there should be a screw under the bowl to lift it up.

steve, May 2005