MY INDESIT WIL 103 WASHING MACHINE RUNS THROUGH ITS PROGRAMME BUT WHEN IT COME TO EMPTY THE WATER IT FREEZES AND THE STAIN REMOVAL, EXTRA RINSE LIGHTS COME ON AND THE DOOR LOCKED LIGHT FLASHES RAPIDLY.

CARL SHEPPEY, August 2007

Hi my indesit 103 sometimes fills then imediatly empties again
ive got to start it again to get going
other times it continues to wash and wont drain
until i switch it to drain then spin
help most appreciated

tom, September 2012

I looked at the bottom of my machine amd there was nothing there the filter was clean

amanda, June 2012

after a cycle has finished all the lighs flash and door dose not open

Amanda, June 2012

The washer will not fill with water, the pipes are straight the water pressure is ok in the house and the power button lights are on ?????

nicola, January 2011

Most modern machines have a feature similar to this, or maybe the program selector knob clicking round. By FAR the most common fault is that the pump filter is blocked either by lots of little bits over time or something getting between the inner and outer drums. 'Colour Catchers' are devils for doing this. At the bottom on the front of the machine there should be a removable kick plate, normally just held by clips. Remove this. There should be (on most machines) a unscrewable filter behind the plate. Empty as much water from the machine as you can by putting the outlet hose into a bucket (or two). Then unscrew the filter. Get plenty of towells ready... There will be lots of water still to come out. Clean the filter and it's housing. Replace and hey presto (hopefully) your machine should be working again.

Paul B., August 2008

widl codes - light flashing from left to right are numbers 1-4

f01 light 4, motor triac
f02 light 3 motor, jammed/ tacho
f03 lights 3&4 Ntc fault
f04 light 2. pressure sw stuck on empty
f05 lights 2&4, pressure sw stuck on full
f06 lights 2&3, N/A?
f07 lights 2&3&4 heater relay
f08 light 1. heater relay
f09 lights 1&4 eprom/setup error
f10 lights 1&3, pressure switch not sensing
f11 lights 1&3&4, pump/draining error
f12 lights 1&2, communication error
f13 lights 1&2&4, dryer ntc/ fan motor
f14 lights 1&2&3, dryer heater
f15 lights 1&2&3&4, dryer heater relay
f16 N/A
f17 light 4, door lock
f18 light 3 comms error (3 phase motor) power board

f1 and f17 share the same light

phil grimshaw, August 2007