the machine stopped before emptying the water, clicks onto the programmes but nothing happens

barbara, September 2007

My service machine washes ok,but I need to drain the water from the bottom before it will spin,then again I need to drain it after spinning.thought it might be a blockage but I have cleared all rubbish that might have caused a problem,could it be the motor/pump attached to the black rubber tube,Help.Jamie

Jamie, June 2009

sounds to me like you have the same issue i had...
where it would not spin and just freezes during the cycle...
it was an issue with a burn out on the logic board i had to re solder a bit on the back of the board... it worked a treat saving me £135.00 i was advised thou that the service 1500 should never really go on the 1500 setting only the 1000 or 1200 as the 1500 causes the board to short out.. eventually is a design fault apparently
:-)

Timski, September 2007

sounds to me like you have the same issue i had...
where it would not spin and just freezes during the cycle...
it was an issue with a burn out on the logic board i had to re solder a bit on the back of the board... it worked a treat saving me £135.00 i was advised thou that the service 1500 should never really go on the 1500 setting only the 1000 or 1200 as the 1500 causes the board to short out.. eventually is a design fault apparently
:-)

Timski, September 2007

hi this is a circuit board fault try these guys

phil grimshaw, September 2007