The gaurd has come off my McCulloch Trim-Mac 240 and the damaged rivet that held it in place has fallen into the shaft where the drive cable turns.This is about 4 inches up from the spool feed,i would like to remove the spool feed etc so i can see if the broken rivot will come out of the tube if i tap it slightyi need help to remove the complete spool feed from the aliminum shaft,or will i be able to use the strimmer without damaging anything with this broken rivit floating around inside,thanks very much
Can you answer this question?
Complete the form below to add your answer to fixfault.com
I can help ...
Guard needs replacing on McCulloch Trim-Mac 240?