GG asked ... Fix food processor motor?    |    T asked ... How do I turn the delay off on Electrolux DX302 dishwasher?    |    Helen asked ... How can I mend my Kenwood Gourmet FP505?    |    Roy Turner asked ... Kohlangaz Gosford HE fire?    |    Peter asked ... How can I mend a Powerwasher PRO PRO1800PWE?    |    Click here to ask your question

A bit stuck?

I went to put an new out side light up...but when I looked in side the old light the wires seemed to be a bit odd...I have 2 brown wires blanked off, 1 earth wire, then 2 blue, 1 blue goes to neut and the other blue goes to live..

never seen this before...any help
clive, April 2008
sounds like switching was done at switch not at the cieling plate. 2 red wires are I (expect ) live coming in from wherever and live to switch. 1 of the the blues is coming back from switch so is actually a live and other blue is the proper neut.
To add switch for out side light.
1 put red with others this goes to common on switch
2take red-brown, black -blue, earth to light
put blue-black at switch with other blue-black as this shoud be neut
red should then go in toother side of red taken from other reds.
wire light up as red live blue neut and earth.
if you have tester take reds apart and only 1 red-brown should be live, test other red-brown should be at other light fitting. It is then like cieling fitting.
1 in from light
1 onto next light
1 as switch wire- with neut as the return from switch.

eddy mccarthy, July 2008
This is correct.

2 browns, 1 from live feed in and 1 to light switch
2 blues, 1 neutral return and and 1 to light switch (so it's live when the switch is on). This second blue should have some brown tape on it.

Connect 2 browns together, both blues to light - either side (1 to live, 1 to neut) and earth to earth terminal.

Jobs a goodun

Mr handy Andy, April 2008