Lou asked ... Mac Allister 35cm electric lawn mower?    |    Ronald Charlwood asked ... Beko fridge/freezer not cold enough?    |    John Broadbent asked ... Advise?    |    suzy asked ... Brother kh-940 not in sync with DAK9 in interactive knitting?    |    Susan asked ... How can I stop my steam iron spraying water with the steam?    |    Click here to ask your question

How to install belt on Maytag washer Model #SAV2655Aww?

How do I get the belt on the drive assembly without dismantling the driveshaft.
Janelle, August 2005
have the same problem with # SAV205DAW, I think the whole motor will need to be removed what a bad design

dave, October 2011
JP is wrong on this one. I have the same problem. Bottom is solid. After taking off lower front panel by removing two screws, motor/belt area is exposed. But belt can only be put on pully under tub. Pulley under motor has water pump mounted below it. Must take water pump off????

Dan, January 2006
Hello,

You should be able to tilt the washer back and access it from under the machine.

JP, August 2005
link Click here to see other fixes for Maytag.