I have a Bemodern Detroit electric fire. My problem is that there is no light coming on. I had a power cut and when the power came back on my fire had no lights, the heater part of the fire worked, but the lighting wont come on anymore. The heating part and lighting work of two seperate switches, dont know if this helps. much obliged.

Tracy Smith, August 2008

I have a Detroit electric fire but the remote control will not work anymore where can I get a replacement remote control for this fire

June, January 2015

I have a BQ Avalon version of this fire. The bulbs are accessed from the front of the fire.
1) Remove the metal surround which is held on by magnets.
2) Remove the two small top screws at either end of the grill above the glass. This keeps the glass in place.
3) Press the glass gently, then slacken the lower two screws of the grill and slide the grill upwards while still holding the glass. Remove the glass sheet.
4) Remove the top and bottom screws from the upright metal strips , attached to the back board, on left and right hand side.
5) Gently ease the logs/coals up. Mine was quite fitting but I could gently rotate it upwards.
6) You can now access the bulbs. Mine were E14 11W coil long life bulbs.
7) Refit in reverse order. Good luck.

Jellybean, January 2015

how to replace bulbs in detroit fire as their seems no way to access the back to change the bulbs???

nick tovey, April 2014

There may have been a slight surge when the power came back on and if the bulb(s) were already weak it may have blown them. Simply replace the bulb(s).

Lee, February 2009