My Diplomat ADP8322 won't drain, and appears to be leaking from somewhere, as the floor under the washer is sodden. It is an intergrated dishwasher and is not easily accessible. I turned the water supply off and the error code was F6 (water supply) however, when I ran the dishwasher before turning the water off, there was no error code, just a wet floor. Any advice at all would be greatly appreciated as the water is leaking through to the flat below!

Many thanks

Ross, October 2008

Thanks FOXY, much appreciated, have an engineer coming out so should get it all sorted.

Ross, October 2008

Hi Ross, possibly the drain hose is holed but with the filling on its own with dirty water, it sounds like it may be syphoning.Is the drain hose up in a loop or facing down.If down, lift it up and tie it up. this will stop it syphoning back.If the water goes to a stand pipe then possibly this is blocked.The machine will have to come out at some stage and properly inspected as the units will swell from the water. all the best.

FOXY, October 2008

Also, the dishwasher has appeared to refill itself!? I have had to scoop the water out myself, and it doesn't seem to be clean water!

Ross, October 2008