GG asked ... Fix food processor motor?    |    T asked ... How do I turn the delay off on Electrolux DX302 dishwasher?    |    Helen asked ... How can I mend my Kenwood Gourmet FP505?    |    Roy Turner asked ... Kohlangaz Gosford HE fire?    |    Peter asked ... How can I mend a Powerwasher PRO PRO1800PWE?    |    Click here to ask your question

how can I sort my dyson cr01?

I have a dyson cr01 washing machine and it will not stop filling up when you start any cylcle, it would quite happily fill up to the top of the drum
Colin and amanda, November 2008
in a dyson machine the pressure switch is part of the front electronic panel not a round switch assembley.
i found the small pipe to the panel can become detached from the connection on this panel this can be checked by removing the top cover making sure to disconnect the power first,.
if this is not the case then you will need to dismantle the machine and remove the front of the machine.then check the small pipe connection on the front of the wash tub the reducing connector can break.replacement parts can be found on the internet(try yourspares.co.uk)

chris, February 2009
Check the pressure switch -the system that determines correct water level in the drum. Its a round item about 3 inches across with several wires connected, it sits under the top cover. Its an air operated switch which tells the machine water has reached the correct level. Disconnect the thin rubber pipe from the switch and blow down through it to clear any blockage. Switch itself may be faulty but its more likely the pressure pipe or the vessel attached to the other end of the pipe is blocked.
Also check the filter - generally located behind a panel at the foot of the machine.Some are obvious like little square hatches and some are hidden behind the trim panel at the foot of the machine. Once panel is removed the filter should be visible. Its generally a circular plastic fitting which unscrews in an anticlockwise direction. Some hotpoint, indesit and ariston filters are located in the big black sump hose (the one that leaves the bottom of the outer drum and connects to the pump). Remove the back cover, locate hose, remove the tensioner clip by squeezing the tabs together with a large pair of pliers or vise grips, remove the hose, take out filter and clean. Be prepared for spillage of water. May help if the machine is tilted backwards at an angle.

Repair and service your own washing machine. Go to www.2ndwave.co.uk/manual.html

dannyboy, November 2008
link Click here to see other fixes for Dyson CR01.