tried to flash box but just getting messages: the reciever was not detected firmware in boot mode click ok and a/c on reciever. waiting for response of your reciever

rumple1, December 2008

havin same problem let me no if get workin cheers

rich, December 2008

the only way i know to get it back is by reflashing it again , i had the same problem with a starview box 2 years ago , i put the wrong firmware into it , and it was stuck on standby , , but when i but the right firmware into it it worked right away , , so dont give up yet , go and get a memory stick and get firmware for all the models of the make you have and try them one at a time , just to get the box out of stand by , thats what i would mick

mick, December 2008

sorry Mick no luck, yes im using rs232 cable 9 pin female 2 female, lights on (vox max,) are red stand by and central 2 verticle green lights, the machine as never been flashed from buying it , but have had to input codes manually for sometime now, looking more like a door stop than ever...

rumple1, December 2008

what a time for a power cut! is there any power lights showing , on the box ? i still think that the wrong file went into it , because its not id the remote, and its stuck in stanby, were did you get the file from ? what web site , i still think that reflashing it is the only way to free it , what make is it , EUROVOX"

mick, December 2008

mick , a power cut happened the the box was locked in stand by after this , no functions from the remote control

rumple1, December 2008

no mick the box was locked and i couldn`t operate it so i thought to try flashing it but as you can see not having any luck

rumple1, December 2008

if the box is locked in standby, thats is because the wrong firmwear file has being put into it , were did you get the file , from what web site?

mick, December 2008

hi mick,
yes to rs 232 cable 9 pin female
box is locked in stand by, and i beleive its blue by 12 vents counting, as you can see im a novice any more help much appreciated

rumple 1, December 2008

i think that you have not clicked the com port off , COM 1 , COM 2 , COM 3 , or its looking at the wrong com port for the link up , to the box from the pc, are you useing rs232 cable 9 pin female cable , or a USB to 9pin converter? have you got the box powerd up , when it tell you too? what make of box are you flashing. mick

mick, December 2008