Mike asked ... Bosch WTA74200GB Vented Dryer?    |    Stuart G asked ... C3 Front Wiper control problem?    |    Clare S asked ... Repair Electriq dehumidifier?    |    Bob asked ... Charger fault?    |    Terry nelson asked ... How to remove the flexible shaft from a curved shaft ryobi t?    |    Click here to ask your question

How can i change the prv on my boiler?

I have a bosch worcester 28i combi. the pressure relief valve is leaking. I bought the new part, but how hard is it to get to? and do i need and special tools?
Jayman, March 2009
If your prv is leaking take notice of the system pressure when the heating is on, if it reaches 3 bar then your expansion vessel has either failed or it needs re filling with air(0.75bar) its better to change the prv at the same

Darren Willims Worcester approved engineer, March 2009
http://www.worcester-bosch.co.uk/installer/literature/discontinued-boiler-literature/discontinued-gas-boiler-literature/28i-discontinued-november-2005-literature


Download the installation manual, it should have a bit near the end about changing common parts :)

Bunslinger, March 2009
just drain the system so theres no pressure, and using a spanner that fits just undu nuts and replace. after wards refil system. not much to it, just make sure u got the right tools.

Ben, March 2009
link Click here to see other fixes for Worcester.