It takes many attempts to get the machine started,it seems to be the progammer,as when it finally starts it does normally go through the cycle.The machine is 4 years old but hardly used and will be a difficult decision to scrap it because of the cost of repairs.Can anyone help please?

Mick, December 2005

i had a similar problem. I recall it was an E90 code
If you leaned on the panel it ocasionally jumped back into life.
I had an extended warranty.
An engineer came out took the front of the panel off and changed a small plug with what I recall as having 3 or 4 small blue wires on it that connected to the control panel.

Derek Smith, April 2009

Ours also 4 years old we were told to use a hair dryer by a repair man as the problem is caused by damp in the control panel. Sometimes it does times it doesnt... but worth a try

Kevin, January 2007

Hi Mick,

I think our 1265 W is doing the same thing - keeps stopping mid cycle and lights go out. You have to hit the start button agin which normally prompts it to start going again but when coaxed along, it does normally finish the wash & dry. Just can't rely on it finishing while you leave it alone. Also sometimes get an E90 error. Did you manage to determine the error in the end as we are also having to consider replacing due to the cost of getting fixed?

Darryl, April 2006

We don't have to open & close door,we sometimes get e90 fault displayed.Thanks for your reply.

Mick, January 2006

if u have to keep openin shutin door to get it to work will be the door interlock

tony, January 2006