The E10 warning keeps comming on when it goes to the rinse cycle.We have checked thewater supply and its fine and also cleaned the filter on the water intake pipe.Ihave noticed that the water from the jet stream is only a trickle and was wondering if there was another filter maybe inside the machine

Elaine, April 2009

The jetstream could be blocked but this will not cause an error code unless the pump fails.check the filter is clean as this reduces jetstream flow.E10 could be a faulty inlet valve coil (normally go open circuit).they should be around 3 to 4kohms if ok.Also check that the drain hose isn't pushed to far down the waste pipe if it is a freestanding one behind the machine.only put 8 to 10 inches of the drain hose down the waste pipe otherwise you can cause syphoning which will give an E10 error code

ck, April 2009