Model GWL11US
Stops at spin cycle...
Error message signals a beep, beep, beep (steady)
and the first light in "wash" is amber, the 5th light in "wash" is green.
Can anybody decipher this error code??
Thanks

dpm, August 2009

RPS error#130 How do I fix this or what could be wrong with my F & P washing machine MW511?

JAYC, June 2014

i have a washing machine model MW512. when i start washing i get a continous beep and the first light (long wash) and the last light (spin) blinking.

nirmal singh, July 2010

1st and 5th from left is code #136 Motor stall.
The motor control module has been unable to start the motor. Possible causes are faulty motor harness, faulty or jammed motor, seized bearings or seals, faulty Motor Controller Module, faulty Rotor Position Sensor or harness. Lid lock fault.
x00000x0 = code 130 Rotor Position Sensor Error.
Each light numbered.
128-64-32-16-8-4-2-1
To determine code add numbers.
0000x00x = code 9 Machine size error.
#37 = Pump blocked error.
#39 = Pressure tube Fault.
#40 and 47 = Basket Disengage Fault.
#43 Out of balance Switch Fault.
#48,#49,#50 = Hot and/or cold water valve fault.
#51 and #52 = Diverter valve fault.
#130 and #131 = Rotor position sensor error.
#132 and #133 = High motor current.
#136 = Motor Stall.
That is all codes listed in service sheet in control housing on back top of machine. Take lid off, 2 phillips screws in back to get control housing off.
The pump mounted beneath the tub will develope leak allowing water to get to the motor causing all kinds of problems.

whkrems, September 2009

Yes I can but I need the exact light sequence. You don't say if the 1st light is the left hand one or the right hand one. It makes a big difference. Read the lights from left to right & copy down exactly which are on & which are off. Post it here & I will look it up for you.

Lincoln Appliance NZ, August 2009