GG asked ... Fix food processor motor?    |    T asked ... How do I turn the delay off on Electrolux DX302 dishwasher?    |    Helen asked ... How can I mend my Kenwood Gourmet FP505?    |    Roy Turner asked ... Kohlangaz Gosford HE fire?    |    Peter asked ... How can I mend a Powerwasher PRO PRO1800PWE?    |    Click here to ask your question

how can i fix my simpson silencio 850 dishwasher?

my simpson dishwasher is leaking water from the bottom left hand corner of door i have replaced both door seal and sorrounding door seal after i replaced surronding door seal it stoped for a while a week may be but started after that and replacing door seal didn't do anything can you help me i am short on cash at moment so it would help alot if i could fix it my self thanks russ
russell wort, October 2004
The complete answer to stopping all the leaks is to completely remove the outer skin. You will find the leaks coming from the guide roller screws for the upper tray. The seals on the inside become brittle and crack. You'll see the water trail on the outer of the stainless shell. Remove the screws (you'll need an appropriate torx driver)and apply some non acetic cure silicone and replace. Now remove all the self tapping screws which secure the front door seal retainer (black plastic), clean it and apply some silicone sealer to its outer edge and refit, tightening all the screws so that the silicone squeezes out a bit. Next unscrew the water inlet nozzle and clean the rubber oring. Apply some silicone to both sides and refit. Screw it on fairly tightly but don't overtighten or you'll strip the thread. The pump assembly oring should also be cleaned or replaced. Remove the filter assembly and bottom spray arm and riser. Undo the four screws and lower the pump assy. Remove the oring and clean it and all the mating surfaces. Slot it back onto the edge of the stainless shell opening and lift the pump assy into place. Whilst holding it in place the filter assy into place inside the dishwasher and replace the four screws. Tighten to compress the seal. It should not leak at all now.

Ian T., November 2015
went to clean filters at bottom of dishwasher and cannot remember how they fit back together, I seem to have an extra piece I don't know what to do with

Julie, January 2014
I just replaced both door seals on my silencio 850 and it still leaked, then i noticed that the upper seal housing ( black plastic ) has come away from the stainless steele interior in the top upper corner so water is leaking past the seal housing and down the side of the door to the floor. Some good water sealant ( bathroom sealant ) between the seal housing and the stainless will fix it.

Moz, June 2011
Hi, following Mark's advise I cleaned the sediments like
small lumps of powder, fat, some nasty grunge from the seal under the bottom of the door and the door bottome as well. There was surprisingly quite an amout of. No more laaking. Cheers

igor, April 2009
Clean the accumulated powder and grunge from under the door, seal, and all area where the door moves.

Hey, presto! No more leaks!!!!!!!!!!!!!!!

Mark, February 2008
Hi my Silencio dishwasher has started doing the same thing! any help would be appreciated! thanks

Tristian, December 2006
there a little screws which screw the plastic housing that the seals fit into these pop out when moved mainly if steel is still warm you need to silocin these screws in
also the draws bang onto seal and pull housing, same repair

Hannay, March 2005
I also have the exact same problem. It appears to be leaking from the bottom left hand corner (front).

Ben, December 2004
We have exactly the same problem so if anyone can help we would appreciate it. Dishwasher bought July 2003 leaked since installation in January 2004. Warranty unable to be utilised as we are in a country that does not have a service agent.

Jane, November 2004
link Click here to see other fixes for Simpson.