I own a Maytag Washer model MAV6000AWW that does not perform cold water washes anymore. I purchased a new switch (4 button) and analog temp control (circuit board) from Maytag and want advise on the best way to replace them.
Thank You

Jess, March 2006

Hi, If the cold valve was plugged are not working there would be NO water flow when the COLD button was pushed!!!

Tom, July 2006

jess, did you check your fill/water valve, this is normally the problem. If cold water is filling slow than its your fill valve, check for voltage at the valve using a DMM(Digital Multimeter). Disconnect cold water line and check for a clogged. If you have voltage than you fill valve is bad. good luck

Kevin, March 2006