my naiko n2850w tv has developed a fault .The picture is pinched east to west like an hour glass .Can anybody help ?Is there sutch a thing as a hiden service menu that I maybe able to adjust the screen?Any help would be a bonus .many thaks.

RICH, April 2006

i had the same problem with mine i found four dry solder joints on the board the only prob is i can only describe where it is as i cant remember what it was!
remove rear cover and as you look down onto the component board around the 5 and 6 o clock posn there is a component around an inch square with 4 soldered legs try looking around there .just ad a solder iron to re heat the joints your components board unclips anyway and can be slid out BUT MAKE SURE YOUR SET HAS NO CHARGE LEFT IN IT BE SAFE . i am in no way what soever an electronics whizz so i am sorry i cant be any more precise. also before i attempted my repair i found that putting preasure on the scart socked made the fault temp dissapear good luck

mick the gyp, August 2008

My phone number is 07802 808751

John B, September 2006

I dont know mate but i'm looking for the same tv's remote control if you want to sell it to me!!!

John B, September 2006

Unfortunately I am not familiar with this brand but most sets have service menus that can be accessed via the normal remote with a specific sequence of key pushing and some with a special service remote. If this problem developed suddenly then it is more likely a faulty component within the east/west correction circuit and requires investigation.

sparky, April 2006