i would try the first 4-dig code first
Proline 0592 349, 100, 054, 065, 040
Programming your Sky remote control
The Sky remote control can also operate the basic TV functions (Channel changing / volume control / Text etc) on around 90% of TV manufacturers. The 4 digit code (Shown in your Sky handbook) is used to identify the make and manufacturer of your TV. The individual 3 digit codes are used for each manufacturer.
To program your Sky remote control using the 3 digit code.
1.Switch on the TV set
2.Press the TV button on the Sky Remote
3.Hold down the Select and Red buttons for 2-3 seconds until the LED blinks twice
4.Enter the 3 digit code
5.Press the Select button to store
Press TV and any number to test, If this does not operate the TV set try below.
To program your Sky remote control using the 4 digit code
1.Switch on the TV set
2.Press the TV button on the Sky Remote
3.Hold down the Select and Red buttons for 2-3 seconds until the LED blinks twice
4.Press the TV button on the Sky Remote again
5.Enter the 4 digit code for your make of TV
6.The LED should blink twice, if not recheck the 4 digit code used and go back to 1
7.Press the standby button on the Sky Remote (The TV should go to standby)
8.Press the Select button to store
If the TV does not go into standby press the TV button then the standby button, then TV then standby, keep repeating this until successful. This will scan the codes used for a particular make of TV.
Programming the Sky Remote control to view Sky on an RF channel
Most installations comprise of a Scart connection from the Sky receiver to the TV. This is normally activated by pressing the Sky button for viewing Sky. For installations where the use of a Scart lead is not possible the Sky button on the remote can be set to instruct the TV to go to channel 6 (Or any channel that Sky is normally viewed on) and switch on the Sky receiver.
1.Press the TV button on the Sky Remote
2.Hold down the Select and Green buttons for 2-3 seconds until the LED blinks twice
3.Enter the program number for the TV channel which Sky is normally viewed on
4.Press the Select button to store, the LED should blink twice
Now you only need press the Sky button to view Sky on your chosen TV channel.
hay88, March 2010
