Lou asked ... Mac Allister 35cm electric lawn mower?    |    Ronald Charlwood asked ... Beko fridge/freezer not cold enough?    |    John Broadbent asked ... Advise?    |    suzy asked ... Brother kh-940 not in sync with DAK9 in interactive knitting?    |    Susan asked ... How can I stop my steam iron spraying water with the steam?    |    Click here to ask your question

ravenheat csi primary boiler fault?

after having had the boiler off for system mods and refilling and direct wiring the pump to circulate any air and re bleeding, when restarting the boiler the pump comes on fan on ign on and boiler fires and after approx 10 secs a thumping noise in the pipes at the boiler is heared then boiler shuts down.have replaced fan control board as similar fault was cured 3 years ago with this and tested pressure switch which clicks when a gentle suction is applied to the clear tube.also fan is spinning free and have wd40 the shaft
any thoughts on solution thanks
paul, June 2011
have you checked boiler isolation valves are open?
if closed, no circulation & boiler overheats

manwithnoname, June 2011
link Click here to see other fixes for Ravenheat.