Bob asked ... Charger fault?    |    Terry nelson asked ... How to remove the flexible shaft from a curved shaft ryobi t?    |    Matt Longmore asked ... Non-start on Flymo XLT 250?    |    John asked ... How to fix my fireplace?    |    Ian Scott asked ... Remove cover off gas boiler?    |    Click here to ask your question

stihl chainsaw model 025, 18 inch cut wont start?

chainsaw will not start, pulled starter rope till my arm hurt. still wont start.
followed start steps still nothing.
MIKE, February 2012
there are many reasons why it might not start. check to see if it is getting fuel by pulling it over a few times then remove the plug is it wet ? will it cough at all ?
do you have a spark take plug out lay it against engine and try pull start your mixshould be 50-1 nothing else pref with a good 2 stroke sthil or similar

daz, February 2012
try changing the fule for a fresh fule , get the mix right dont make it so strong , take out the spark plug and clean it or change it for a new one , clean the airfilter, use the choke to start it , and when the choke kicks is , knock the choke off and try start it , if you keep the choke on , after it kicks" you will flood it , if you think you have flood it , try pulling the cord 6 0r 7 times with the saw turned off , to dry off the spark plug , then try it with the choke on" till it kicks , then put it to start to try it , the trick is to master the choke, 3 0r 4 pull with the choke on , showld kick it in , you will feel the differance when the chock kicks in , that will be the easy one, and you will hear it kicking in , then knock the choke off and try it,,

l, February 2012