3 hours ago Karen asked ... Royal 480nt cash register?    |    andrew smith asked ... 2009 fiesta 1388 cc titainum?    |    Eric asked ... Strimmer fuel line?    |    Frank asked ... Working fine. No cold air?    |    c.m.brown asked ... Replace chuck on aeg power drill sb2e 700r?    |    Click here to ask your question

Replacing brushes on Exxcel 1400?

In attempting to replace the carbon brushes on my Exxcel 1400 I find the replacement brush on one side is too long to slide in as a yellow block is in the way. This will not allow the longer brush to go into the channel. What should I be doing?
Pegatome, June 2012
Needs a good pull to achieve this. Take motor out to fit properly it is really worth it. Check with torch at end of motor to see if both brushes located at correct angle onto spindle.

Pegatome, June 2012
link Click here to see other fixes for Exxcel 1400.