3 hours ago Karen asked ... Royal 480nt cash register?    |    andrew smith asked ... 2009 fiesta 1388 cc titainum?    |    Eric asked ... Strimmer fuel line?    |    Frank asked ... Working fine. No cold air?    |    c.m.brown asked ... Replace chuck on aeg power drill sb2e 700r?    |    Click here to ask your question

Removing the PCB ?

To remove the PCB do I have to remove the cover from the back of the fire
Steve, December 2014
The glass is held in by a plastic quadrant at either side,the quadrants are held in by 3 screws each at the back,hold the quadrant while removing screws to stop glass falling out then lay fire on it's back to remove quadrants and glass,be careful when removing glass as it's fitted up into canopy,lift glass at the bottom about 5mm then slide down to base to free it,the PCB is now accessible

toptrish, December 2014