3 hours ago Karen asked ... Royal 480nt cash register?    |    andrew smith asked ... 2009 fiesta 1388 cc titainum?    |    Eric asked ... Strimmer fuel line?    |    Frank asked ... Working fine. No cold air?    |    c.m.brown asked ... Replace chuck on aeg power drill sb2e 700r?    |    Click here to ask your question

Humax HDR Fox T2 on the blink?

I have an HDR Fox T2 which is on the blink. I've tried factory re-set (worked fine) and have also downloaded the company's software and installed it through the USB port (also worked fine), but the problems remain: controller stops working (freeze out), doesn't record, won't backtrack, sometimes says 'nothing being broadcast on this channel'. Switching off at plug brings it back/controllable for a short time and then we're back to the freeze-out.
Can anyone advise?
Many thanks! Malcolm
Malcolm, January 2016
Had a Hummy HDR some time ago that I "acuired" as non-working. Turned out to be acracked track under the PSU board (If I recall correctly, around the inductors close to the output conections). A few minttes with some tinned stranded wire and careful bridging all the dodgy track and it was running again.

You could check the PSU capacutirs - some fail.

See also some dedicated Hummy forums

http://hummy.tv/forum/threads/dead-box-can-any-one-help.2385/

https://www.avforums.com/threads/humax-hd-fox-t2-hd-receiver-master-thread-part-three.1487039/page-9

Loads more out there.

XXX, January 2016
link Click here to see other fixes for Humax HDR-Fox T2.