Emma asked ... Foot pedal smoking?    |    Morne asked ... My defy dtl 125 toploader?    |    Ernie asked ... How to fix gearchange ldv maxus van 2006?    |    Cuckoo asked ... Changing batteries on a fixed bt corded phone?    |    Marc Nollid asked ... Nissan Micra mk 5 2018 rear seat mecanism?    |    Click here to ask your question

My potterton netaheat 10-16 boiler stopped working!?

When the room thermostat gets below temp, the boiler kicks in (pilot light and fan) and makes all the right noises but it does not seem to light up to heat the water. On a few occasions it does for just for a few short mins but then stops (fan keeps going and pilot light stays lit) Checked room theremostats etc
It's had a new relay but no joy!
Simon (s.roe@ukonline.co.uk), January 2005
Same Problem too.. You know know were I can get the Mercury Vapour Valve from do you?

Bazzo, February 2006
IF YOUR BOILER FIRES UP AND RUNS FOR A FEW MINUTES AND THEN STOPS. CHECK YOUR ROOM STAT FOR CORRECT OPERATION, ALSO CHECK THE SETTING YOU HAVE ON YOUR BOILER CONTROL, IF THIS IS TOO LOW THE BOILER WILL KEEP CUTTING OUT. I NORMALLY RUN AT 3-4 SETTING. HOPE THIS HELPS.

ERIC ILIFFE, February 2005
same here mate, turns out it is probably the mercury vapour switch.
good luck

Nick, January 2005
link Click here to see other fixes for Potterton Netaheat 10-16.