on start up, pump runs and empties m/c then warning lights flash indicating anti flood device has activated, m/c then stops ? sounds like a water level sensor is stuck in the high position, but cannot locate it, any ideas. ?

Dave, September 2007

the anti flood device kicks in if water is in the bottom of the dishwasher this stops it working as there is a float in the bottom that triggers a switch to tell the machine to stop working.

try tipping the washer back ove this will get the water ou so make sure you have a towel at hand.

the machine should work again if it does stop again then you have a leak.
check the pipe inside the dishwaer at the top right hand side this sometimes comes loose.

or take side panel off run program and check for leaks.

scot, September 2007