Hi all again,
My above mentioned hoover washer still won't fast spin eventhough I've fitted brand new motor bushes! I have checked all the spade connectors around the motor and they are all fine and connected, what happens is when I fit the motor brushes is that it full spins once then returns to the no high spin state afterwards. (Thanks to Aa for the previous advice!)
I'm at my wits end!
Arrgggg :(
Ta v much for any light you can shead on this problem!
grumpy Evo :(

EVo, April 2005

I think this fault really should be inestigated by an engineer as electrical/electronic faults are much too advanced for a DIYer

will, April 2005

it could be the sensor on the end of the motor check to see if it is firm and not moving after that I think its time to cut your losses and get an engineer in

aa, April 2005