Pam asked ... Do I need to open the housing to dry the motor?    |    James asked ... Remove enterprise enrolment from an Asus Chromebook C523N?    |    tom schwartz asked ... Bosch maxx 6?    |    Noman asked ... Reverse light switch?    |    Suzie asked ... Stuck Feed dog?    |    Click here to ask your question

Help, Vokera Linea 24, dilema?

Hi,

Please help as I have read all the postings on here and I am now not sure.

My boiler pressure is at 3.5, sometimes above and rarely drops. There is water dripping out of the pipe outside. When the shower is on, it runs hot then cold and so on, this used to occasionally run cold for a few seconds, however gotten worse and now only runs hot for 4 secs then cold for 4 secs etc. I have watched the flames in the boiler and they seem to cycle on and off. The temp rises and then the flames stop in which the temp falls and then the flames rise again.

After reading the postings, it would appear it may be 1 of 2 probs, Expansion vessel or ?? 'Plate heat exchanger' ?. I am confused, I have had someone out but they said it could be the heat exchanger and would replace it but there is a chance it might not work in which i would need to replace the boiler. Someone else has told me Expansion vessel. Is there anyway of really knowing. I just don't want to waste money on something that will not work. Many Thanks
Coreen, November 2007
I had a similar problem on the same boiler, i.e. ignition going on-off resulting in a little hot water then cold, then warm, then cold, etc, and the solution was to replace the Ignition Control Box, cost about £70 plus fitting. Hope this helps
PS: I think Vokera are cr*p boilers as I get a problem with this every few months and is less than 5 years old

Shaf, November 2007
link Click here to see other fixes for Vokera.