The system ran at 20C degrees for a long time, with power down over night for about 7 hours on clock.
Went away for a few days, turned temp to 18C - system shut down and all seemed OK.
NO!
The system has now reported 0.5bar, and a VERY gentle turn on the blue pressurization knob now results in a leak from under the left hand side of the boiler, what is this please?
If heating turned off on boiler & system power failed, we can get hot water, but no heating.
Last time similar happened we had a new diaphragm and some expansion vessel in the loft added, so why does this boiler not cope with normal adjustment of the hall temp dial, and how often should the system be bled and re-pressurized? Or have we got a rubbish boiler or install?
Thanks, Martin

Martin, November 2007

If you trace the pipe from the filling tap you'll see that it is clipped into a plastic bend then a brass union on the left of the boiler, underneath this there is a small (drain?) hole which is probably where the leak is from. I'm unsure but probably needs a new O-ring, if you're unlucky it might be the plastic bend needs replacing.

You shouldn't have to bleed/re-pressurize the system often, if you keep losing pressure get a Corgi Reg. fitter in to have a look.

Dannyboy, December 2007