240v belle cement mixer tipped over ?

Hi all my mixer tipped over by some stupid Labourer Now the drum won't spin motor seems fine I was wandering if anybody had any ideas what could of happened Any information would be appreciated ... more

done

performance 780 generator?

My performance 780 generator suddenly stopped, fuel at the plug/ and spark at the plug, but it won't start with or without choke. Can you please advise.

bosch drill with hammer?

to replace the chuck on a 1182.7 due to wear

done

How can I fix my belle mixer?

Can anyone tell me the compression reading for my belle 150 petrol mixer? Bought roughly 2007?

Pro mitre saw blade guard?

I have a Pro CLM210LSMS mitre saw. I made the mistake of taking off the blade guard mechanism when changing the blade and now cannot see how to reassemle it with the tensioned spring. Does anyone kn ... more

Is my Mitre saw worth repairing??

I have a Performance Power Compound Mitre saw. I was cutting a small log which got stuck in the blade and broke the cast aluminium guide. However, the blade has now disengaged and does not spin unde ... more

done

Where can i buy a replacement cut out button CLM250LTS ?

When the cut out button trips it will not click back so cannot use the saw. Where can i get a replacement please Pro saw CLM250lts. Bought from B&Q

done

How do I remove & refit blade guard?

How do I remove & refit blade guard on a Compound mitre saw FMTC210MS

Power Devil PDW5014 Parts?

Where can I buy parts for the above mitre saw. I need the housing and bearing that transmit power from the motor to the blade. I can supply a photo of the part

pp1100ms 1100w mitre saw?

the blade guard will not lift when I try a saw cut

Ref: Pro Performance 1700W Circular Saw?

Stupidly I put the blade on backwards, and on undoing the centre bolt to rectify.. I found that the shaft locking button for some reason won't stop rotation, and the bolt is less than halfway out and ... more

done

where can i get manual for pro portable table saw with laser clm1500tss?

can I get a manual for pro portable table saw with laser clm1500tss

done

Mac allister mrs1400?

Blades won't rotate not motor

done

where can I purchase a replacement part ?

Where can I buy a replacement waste collection bag for a Performance Power blow/vac model PP1800 original made for B&Q ?

how to fix?

My saw runs but blade does not move? is it worth fixing, can I try something?

done

mitre saw dead?

Hi changed the blade on my tooltec 1800 mitre saw now it is dead I think that I removed a screw that I should have only loosened can you help.

bell 150 110v fitted new switch ?

fitted new switch to 110v 150 model. motor runs when button held in ,but wont keep running. were do i go from here. thanks

done

How to stop my chop saw blowing the plug fuse?

My ten inch rebar chop (mitre) saw keeps blowing the plug fuse when I pull the trigger.

done

Is there a manual for the Performance circular saw FMTC10TS?

Is there a user/service manual for the Performance circular saw model FMTC10TS, as i have been given one.

done

how to fix mac allister 1800w miter saw?

prest spindle lock when moter was running now it wont start