GBC Ultima 65 laminator?

My GBC Ultima 65 laminator keeps overheating because the bottom roller wasn't heating, so the top would get to hot. We replaced the bottom roller and heat core but it is still not heating. Is there a ... more

done

GBC Ultima 65 not sealing edges?

My preschool has a GBC ultima 65 that doesn’t like to seal on the edges or between pieces of paper run side-by-side. I’ve adjusted everything I can think to adjust(front/rear roller pressure, film ... more

gbc ultima 65 laminator film wrinkling?

When I run copy paper through the laminator the my paper comes through with wrinkles on it. What can be causing this. I checked the tension and cleaned the rollers. Could it be caused by static?

Laminator gbc ultima 65 How to reinstall a power switch?

I had a wire burn out to the power switch and it burned a post off the switch. I have purchased a new switch and I need to know how to re wire it. GBE ultima 65 laminator.

done

How can I stop GBC Ultima 65 from overheating?

How can I stop GBC Ultima 65 from overheating? It doesn't want to maintain proper heat range.

GBC Ultima 65 rollers just arollin' nonstop?

Help. I have a GBC Ultima 65 which turns on, but the rollers immediatly run. The control panel seems ok, i looked at it and cleaned it. The roller heats, and green light comes on when ready. The r ... more

done

Our GBC laminator ultima 65 heats but does not roll forward? Suggestions?

Our laminator heats up but will not engage and roll forward to feed laminator film through. Any suggestions?

laminator is not heating up?

I have GBC Ultima 65 laminator, all appears to be working fine except heat light is blinking all the time and Am Not getting any Heat on rollers? What do I need to do to get heat to come on? I bough ... more

how to fix GBC Ultima 65 roller that won't heat up?

The top roller of our GBC Ultima 65 heats up but not the bottom roller. What might be wrong and how do I fix it.

done

GBC Ultima 65 Breaker?

I've got an Ultima 65 that trips its breaker every once in a while. It's not frequent (once every 3 months or so), but I was wondering what causes that and should I be concerned?

done

Heat light continues to flash on my GBC Ultima 65 even though it is ready?

The heat light continues to flash on my laminator even though it says it's ready. Why is that?

done

GBC Ultima 65 Smells Hot, Like It's Burning?

I've Cleaned the Residue From the Ends of the Heat Rollers and Users Say It Still Smells. They have theorized that the heating elements are bad. Is it possible they are too hot? Is the temperature ... more

done

our GBC Ultima 65 control panel is not on?

Our GBC Ultima 65 control panel is not on. The laminate frolled into the heat rollers and the control panel shut off and is not on at all.

done

GBC Ultima 65 Power Switch Failure?

The AC Switch on my Ultima 65 burned out/melted. I replaced the switch and that one melted, too. What would be causing this? Could it be caused by corroded leads on the wires plugged into the switc ... more

done