john deere model 68 rear engine riding mower!?

i just bought a john deere model 68 rider the wiring is all jacked up i have been trying to find some wiring schematics with no luck. the model number on the motor {briggs and stratton} 19170 type 242 ... more

done

engine will not run?

john deere 240 with 14hp kawasaki fc420 gas to carb, spark okay, will start with ether but will not run

done

How do you remove and replace the mower deck on the John Deere L130 tractor?

I just need to get the blades replaced but can't find the manual to step me through the process of removing the deck.

done

Can I get a diagram of how to replace the belt on a John Deere Sabre mower?

I have the belt, but need to see a diagram of what it looks like when on correctly. Can you help? The mower is a John Deere Sabre model #280777 type 0662A1 code 9511294a.

done

L130 john deere belt diagram?

belt came off and I can't figure out how to put it back on, 48" deck

done

John Deere RX 75 with no reverse?

Recently inherited a RX 75 riding mower and it seems to have no reverse. Any ideas?

done

blades dont spin properly on john deere L130 about 5 years old?

was mowing and a spring flew out from underneath, now blades barely spin.How do i find out what spring broke on my 5 year old deere L130

done

I have an old John Deere 111 that had a 12 hp briggs engine model 281707?

type 0198-01 code 89022411. This motor has one wire coming from the alt and no wires coming from the bottom of the carb. The new engines that i'm looking at all seem to have two wires coming from the ... more

done

John Deere Z225 Electric PTO Clutch?

I have a zero-turn John Deere Z225 mower. The Stud on the PTO clutch broke loose, allowing the PTO clutch to spin on the shaft, pulling the wires loose. It broke the plastic in which the wires were ... more

done

Why does my John Deere 165 will soak up all the gas in the ?

Why does my John Deere 165 seem to want to start ,but then it quit? I need to put gas in the carburator to make it start and then it quits.

done

fuel system john deere lt155?

anyone have feul system diagram? mower wuit running while plowing snow, took off fuel filter to change, and got no gas at all coming out....just need to find how to take tank off and where all the li ... more

done

Need a wiring diagram?

Can anybody out there tell me where I can get a wiring diagram for a John deere 285 Lawn tractor with Electonic Fuel Injection?

done

craftsman 6.5 eager 1 no start?

have a craftsman 6.5 hp eager 1 model 917.377271. believe it to be a tecumseh. got from my father when he bought a john deere riding mower. only starts when ethered, and then only for two seconds or s ... more

done

john deere 50 water pump repair?

how do i get the impeller off the shaft to replace the bearing on my john deere 50 water pump.

done

john deere 2040 rev counter,opu cab,1981,serial no 385222?

the rev counter on my john deere 2040 does not work,yet it records the hours, does the sender on front of engine operate both,can anyone help please !!!! paul

done

rev counter on john deere 2040 tractor?

the rev counter does not work, yet it still registers hours,it is electronic rev counter, any ideas!!! regards paul d

done

John Deere L130 is melting electric PTO switches?

Just out of the blue my 2005 L130 melted the electric PTO switch. Bought a new one and that one got hot also. The electric clutch comes in easily but drops out after the switch problem occurs. Have ch ... more

done

How do I loosen the belt on my 1999 Scott, by John Deere, 1742G?

I just replaced my old ragged belt with a new one...suposedly of the same length. Problem is that it is too tight. I can't find a service manule after 8 years and can't figure out how to loosen it. An ... more

done

How to install belts on John Deere RX 75 Riding Mower?

I have John Deere Riding Mower RX 75 with further identification MORX75X430469 powered by 9HP Kawasaki. I desperately need belt install diagram for this mower.

done

John Deere L111 w/20 hp B & S?

Where do I locate the cooling fins for cleaning? Engine dies after a few minutes operation.

done